| Most viewed |
Ultrasabers' Luke ROTJ conversion kit. (The "crystal" is a total gimick.)196 views
|
|
Still functional, the MR LED strip is covered by a foam casing.171 views
|
|
This was honestly the most difficult part of the whole process, but it finally came out!170 views
|
|
The LED strip that makes up a Force FX blade.169 views
|
|
Close up of the LED strip and its foam casing.165 views
|
|
The guts of a Master Replicas Force FX lightsaber.164 views
|
|
LED strip inside the foam casing.164 views
|
|
The Luxon LED is already soldered and mounted to the heatsink.163 views
|
|
Remove the battery compartment and disassemble the switch assembly.158 views
|
|
Interior of the pommel, battery compartment removed, and black plastic ring yanked out.156 views
|
|
The blade assembly is then forced out the end of the hilt, and the hilt is set aside.155 views
|
|
Finished lightsaber with the Ultrasabers blade, after drilling and tapping a hole for the blade set screw.155 views
|
|
Interior ring of black plastic must be ripped out before the blade assembly can be removed.151 views
|
|
Testing the new LED without the blade.149 views
|
|
Converted saber, with the original FX blade.148 views
|
|
Converted saber, with the blade removed - the point of the entire exercise. And it makes an excellent flashlight, too!147 views
|
|
| 1700 files on 107 page(s) |
 |
1 | |
|
|
|
|
|
|
|
|
|
|
|
